The OREI 3-port switch has a 48 Gbps bandwidth, which is the full HDMI 2.1 pipe, and lists 8K at 60 hertz, 4K at 120 hertz and 1080p at 240 hertz. It also lists variable refresh rate and auto low latency mode, two features that gamers use on newer consoles.
The three inputs suit a console, a streaming box and a Blu-ray player. Auto switching selects the input that powers on last, and manual switching or the remote overrides it. A claim of 8K is largely irrelevant unless you own an 8K display, but the 48 Gbps figure is what lets 4K at 120 hertz pass cleanly. Against the Anker, the OREI is the more capable switch.
Use Ultra High Speed HDMI cables on every connection, since a cheap cable is the usual cause of a blank screen at 4K120. Place the switch where its remote can see the sensor, and keep the cables short. Set each console's output to the highest mode it supports and confirm in the TV's info screen that 4K at 120 hertz is active, since a quiet fallback to 60 hertz is the most common surprise. If a source shows no signal, turn the TV's HDMI port to its enhanced or UHD setting.
What works
- 48 Gbps bandwidth passes 4K at 120 hertz
- VRR and ALLM support for gaming consoles
- Manual and auto switching with a remote
- Three inputs cover most home theater setups
Watch out for
- Only three inputs may not be enough
- 8K support is unneeded for most TVs
- Requires Ultra High Speed cables to hit its limits
Specs
- Ports
- 3 in, 1 out
- Bandwidth
- 48 Gbps
- Resolution
- 8K@60Hz, 4K@120Hz, 1080p@240Hz
- Gaming
- VRR and ALLM
- Switching
- Manual and auto, remote






