The BRIGHTWORLD is a 5.9 in moon lamp with a textured 3D-printed sphere on a stand. A touch ring on the base cycles through seven colours, and a remote switches among 16 colours. A 500mAh battery recharges by USB, so it works without a cord for a while.
The tradeoff is that a larger sphere takes more shelf space and a 500mAh battery does not last long at full brightness. Compared with the 4.8 in lamps, it shows crater detail more clearly but costs more. Colour-changing modes are fun but add little useful light, and a warm white is the setting you will use most.
In ownership terms, charge it with a USB cable before it runs flat, keep the sphere away from heat and avoid dropping it, since printed spheres can crack. Wipe it with a dry cloth. It suits a bedroom shelf or a desk where the surface detail will be seen. Place it where it can be viewed from a few feet away, with the stand on a flat, non-slip surface, because the sphere is light and a nudge can tip it. Switching the room light off shows the texture best, as the inner light throws the crater ridges into relief.
What works
- 5.9 in sphere shows crater detail more clearly than smaller lamps
- Touch ring and remote give two ways to change colour
- Rechargeable 500mAh battery means no cord needed for a while
- Wide stock and the most common name in roundups
Watch out for
- Battery capacity is modest at higher brightness
- Larger sphere needs more shelf space
Specs
- Diameter
- 5.9 in
- Colours
- 16 by remote, 7 by touch ring
- Battery
- 500mAh USB rechargeable
- Control
- Remote and touch ring
- Build
- 3D printed sphere on stand






